If there is one area in the kitchen and bathroom that we forget to clean, it is the tap. And yet, this accessory accumulates bacteria and traces of all kinds. Limescale deposits are particularly unpleasant to look at. So how can they be removed? You’ll be interested in this tip!
Don’t neglect limescale deposits on taps!
When cleaning up the bathroom or kitchen, we concentrate on the dirtiest areas of the room. Sink, toilet bowl, etc. We give these areas a thorough cleaning to reduce the proliferation of bacteria. But the tap is not always one of our priorities! Yet it is an important part of our house that is often in contact with limescale.
Limescale residues are not pleasant to look at. This is one of the main reasons why we try to remove them when cleaning. The traces that this substance leaves are white and spread everywhere. This gives the whole room a neglected look. At the same time, it prevents the proliferation of bacteria in the house.
Limescale also causes malfunctions in our sanitary facilities. When deposits build up, they can block the pipes. In the case of the tap, this can reduce the flow of water. The problem will then become particularly unpleasant to deal with over time.
Two ingredients to eliminate residues and stains
Only two ingredients are needed to remove limescale deposits The first is none other than vinegar. This kitchen ingredient has degreasing and disinfecting powers that we cannot neglect when cleaning our taps! Especially since it easily eliminates bad odors in our toilets.
But you will also need some water to carry out this trick! This ingredient is very basic when it comes to cleaning. It cleans but is not thorough enough to be used on its own. Especially since limescale comes from mineral deposits in the water. So it would only make the situation worse if you used it on its own to clean your tap.
Remember to use the same amount of water and vinegar to clean your tap. This will remove limescale without affecting the quality of your bathroom fittings. It is important to remember that vinegar is a mild abrasive.
Clean limescale deposits with this method
After mixing the vinegar and water, pour the solution into a spray bottle. This will make it easier to apply the product to the tap and other surfaces that you need to clean. Don’t hesitate to cover the dirtiest and most stained areas of your bathroom thoroughly.
Leave the product to work on your tap for a few minutes. This will help to remove limescale deposits and make them easier to clean. Only then should you scrub the tap with a soft brush. And that’s it!
